How to Connect the Circulation Pump

Connecting the circulation pump - is an option for those who want to take over control of the system of heating in your home. The heating system, equipped with a pump, heats evenly and allows you to reach a higher temperature in the room.

Install the circulation pump is recommended with a horizontal shaft. If you install the pump with vertical shaft arrangement (i.e., the electric motor up), it is possible accumulation of air in it, which will prevent the lubrication of bearings. Mounting of the pump can be made both on the return pipe, and the heating flow pipe house. Eliminate during installation possible mechanical stress!

Pick a place where you will install the 12V hot water pump. It is necessary to select it considering the fact that access to the pump has not been hampered in the future. Install the pump after all work on the system, so installing it should be the final step in the installation of heating systems. If the heating system has been used, it should be thoroughly rinsed.

Cut the pipe where you plan to install the pump, and weld it to the connection valves. Before the circulating pump, the shut-off valve must be installed - it is necessary for the convenience of pump removal for cleaning or repair. Consider also the removal of the air, if you want the pump to work long and reliably. And if you need any heating systems parts, you can get them from Banggood. Also you can easily electrical gadgets and tools there, for example, aquarium powerheads for sale, 110V timer switch, etc.

Weld the pump in the following order: check valves - Pump - Valves. When installing, observe the flow direction of water or other coolant, as well as directional arrows on the pump housing. After welding, check the tightness of seams and fill the coolant heating system.

Connect the power cord to the pump. Electrical connection of the pump should be carried out taking into account all applicable technical standards and regulations. The minimum distance between the electric cable contacts the axles must be 3 mm and the cross-section of not less than 0.75 mm square. The cable must be provided with a switch or plug. Turn on the cable outlet.