How to Install a Water Pump

In places there is no central water supply wells are drilled and set the pump (e.g. a high pressure water pump). The most common method of obtaining water, which does not differ from the use of conventional water supply system, is to install a vacuum pump station storage tank, which is mounted to the pipe, valve, and connect the Titans, showers, washing machines, dishwashers, etc. Pumping stations need to properly mount and install. This can be left to professionals or to make installation yourself, observing certain rules.

The 12V high pressure water pump should be installed as close as possible to the water source, that is, to the well. The room for the station setup must be dry and warm. Install the equipment in places with negative temperature values ​​are strictly prohibited. If the room is high humidity, a box with the contacts will get wet, leading to failure of all unit functions. Securely fasten the pump with the help of screwing the legs to a rigid, stable surface. At work there is a strong vibration, and if you do not perform properly secured, the pump will move.

Pipes need to connect reliable, for example made of metal. Through the rubber hoses run pump station impossible. The diameter of the tubes must correspond to the diameter of the pipe. Installation is done by installing a check valve on the well, it is securely attached to the tube pump station and from the receiving valve is mounted the entire system of water pipes. To tap into the system did not have air pockets, lining of pipes have to do with the rise in the direction of the station. The degree of recovery must not be less than 10-20 cm.

Connecting pump station is carried through a separate outlet with ground and safety guns that will protect against short circuit and, as a consequence, against breakage. Unscrew the cap on the tank, fill with water, screw the lid, turn off the tap and only then start the pump. This will release the air from the system, which is formed during assembly.